433MHz Wireless Remote Control Switch RF Relay DC 12V 24V Transmitter 433Mhz Remote Control Gat F

Universal 433mhz receiver
SECIFICATIONS:
1. Power supply: 12v-24v DC2. Frequency: 433.92Mhz3. Codes: can work with any fixed/learning/rolling codes4. 2 channel5. Working temperature :-40- + 806.Built in Aerial antenna : Reception range 10-50m
PROGRAMMING:
Momentary working model:1.Learning transmitter’s codes:Press “learn 1” or “learn 2” for 1 second, the “learn_led” light, then, press the button which you choose on the transmitter till the “learn_led” flash and go out, the transmitter’s code has been stored.• Repeat the above steps for other transmitters.2.Erasing transmitter’s codes:Press “learn 1” or “learn2” and hold on to make the “learn_led light till go out, all codes of transmitters which had been stored are erased.ANT – Receiver AntennaCH1 – Relay Output 1CH2 – Relay Output 2V+ – Voltage +GND – Ground
Products advantage:
1) Can learn Fixed and Rolling code 433,92Mhz remote controls separately and simultaneously !!! 2) Can learn and use most Original 433,92Mhz Fixed and Rolling code remote controls !!! ( Such as : BFT, V2 , DitecCAME, MOOVO, MHOUSE PUJOL, GIBIDI, DOORHAN, ATA PTX4, MARANTEC ) 3) 2 channel receiver provides you with an option to control and use 2 gate automations or alarm systems simultaneously 4) 1 relay can store 50 pcs remote control, the receiver can store 100 pcs remote control
433mhz Remote control
Specifications: Material: Plastic + MetalOperating frequency: 433.92MHzUsage: For 433Mhz RF receiver rolling codeNote: This is not a clone remote. Cannot clone other remotes
Wide range of uses:
Garage doors, Electronic gates, Barrier gates, sliding doors, automatic doors, rolling doors, shuttersElectrical appliances/Home automation i.e. lights, Alarm system, access control systemSometimes you need more remote controls for your gate, alarm, fire alarm or any other system. To buy a few additional original remotes for your gate and alarm system is quite expensive.So this is the best and much cheaper solution for you!!!
Easy to use:
How to programMomentary working model:1. Learning transmitter’s codes:Press “learn 1” or “learn 2” for 1 second, the “learn_led” light, then, press the button which you choose on the transmitter till the “learn_led” flash and go out, the transmitter’s code has been stored.• Repeat the above steps for other transmitters.2. Erasing transmitter’s codes:Press “learn 1” or “learn2” and hold on to make the “learn_led light till go out,Learn 1 to delete channel 1Learn 2 to delete channel 2