Wireless RF 433Mhz 330Mhz Copy Remote Control Auto 4 Channel Code Garage Gate Door Garage Doo

Transmitter For Gate Garage Door

The chipset compability : All of Fixed code and learning code

2260(All the manufacturers)

2262(All the manufacturers)

PT2264,5326(All the manufacturers)

SC5262,HT600,HT680,HT6207,HT6010,HT6012,

HT6014,SMC918 Series,527(All the manufacturers)

1527(All the manufacturers)

2240(All the manufacturers)

Some 433Mhz Brands compatible (rolling code) :

For BFT MITTO2 MITTO4 (old version)

For BENINCA TO GO WV

For DOORHAN TX4

For NICE FLORS

For V2

For NOVOFERM

For FAAC XT4 433RC

For KEY TXB-42R

For ATA PTX4

For GBD AU1600

For Nice-Smilo

For ROSSI

For MotorLine MX4SP DSM

For DEA MIO TR2

For Peccinin TX3C

For Centurion NOVA

For AN MOTOR AT-4

For FADINI JUBI

For Hiland

Remarks:

For fixed code &learning code remote controls, the duplicator will work after duplicating.

But for the rolling code brand listed above, please follow the original manual to program the duplicator to receiver after duplicating

Here is the way of copy

Memory clearance

1.Press button 1 and 2 simultaneous until LED flashes 3 times

2. Release button 2 (Keep pressing button 1), and press button 2 slowly for 3 times, LED flashes quickly.

3. Release both button, the duplicator is ready for copying

Duplicating

Put duplicator aside of original transmitter, as close as possible.

Fixed code remote control:

Press and hold button 1 of original transmitter, then press and hold button 1 of duplicator until you see the duplicator's LED flashes means the duplicating succeed.

Repeat above step to the rest buttons. The duplicator will work after duplicating.

Rolling code remote control:

Press and hold button 1 of original transmitter, then press and hold button 1 of duplicator until you see the duplicator's LED flashes means the duplicating succeed.

Once 1 button duplicated, the rest buttons will generate automatically, please follow original receiver manual to insert the new duplicator on the receiver.

If you erase the code by mistake, you can resume it by pressing and hold both of the ”3” and ”4” button on the remote controllers at the same time, after 10 seconds, the LED flashes 2 times and turn off which indicates the code of the copy remote controller is resumed.