1PCS 10-30V to 12-35V Step Up CV CC 150W 10A DC DC Boost Converter Car Power Supply LED Driver Charger Adjustable Voltage Regulator

Module characteristics: non isolated booster module (BOOST)
65 * 56.5 * 23 (L * W * H) (mm)
Input voltage: 10-32V (default low voltage operation, low voltage operation is used for instantaneous power failure of automobile electric fire.
The module cannot operate under low voltage for a long time.
Output voltage: 12-35V (adjustable)
Output current: 10A (maximum)
Input current: 16A (MAX) (please strengthen the heat dissipation above 10A)
Output power:
Natural cooling 100W (MAX) and enhanced cooling 150W (MAX) (when using, please decide whether to add a fan according to the actual situation,
The temperature of the heat exchanger must not exceed 80 ° C.)
The 65W 90W dual core notebook is easy to handle.
Use 12V battery to drive 19V 3.42A notebook, and the module temperature is about 45C
Conversion efficiency: 94% (measured at input 16V and output 19V 2.5A)
Output ripple: 2% (MAX) 20M bandwidth
Operating temperature: industrial grade (- 40c to+85c) (the ambient temperature exceeds 40c, the power consumption is lower, or the heat dissipation is enhanced)
Full load temperature rise: 45c
No load current: 25mA typical value
Voltage regulation: 0.5%
Dynamic response speed: 5% 200uS
Short circuit protection: None (Please install fuse and protective circuit at the input port.)
Input reverse connection protection: None (Please connect diodes in series at the input port.)
Wiring mode: no welding, terminal block
Preventive measures:
1.12V conductor less than 1m in length shall not be less than 1.5m2. If the length is more than 1m, please thicken the conductor.
2. When the module is working at high power, high temperature and casing, please install a fan. For small power, no fan is required.
3. In use, the input cannot be reversed and the output cannot be shorted.
4.12V battery discharge voltage shall not be lower than 10.5V, and lithium battery used in series (single 3.7V) discharge voltage shall not be lower than 2.7V.
5. In+: input positive pole, IN -: input negative pole, OUT+: output positive pole, OUT -: output negative pole.
Scope of application
1. DIY is a car power supply with adjustable output. You only need to connect your 12V power supply at the input end. The output voltage can be adjusted freely and continuously (14-35V), but the output voltage cannot be lower than the input voltage.
1) On board notebook power supply.
The input is connected to your 12V power supply, and the output can be adjusted to the laptop voltage.
2 Booster charger can use 12V power supply to charge batteries higher than 12V, such as 24V batteries.
3 As long as the voltage is adjusted to the voltage you need and the current does not exceed the rated current, the power supply of your electronic equipment can work normally.
4 In the previous system level power supply, when you were working on the project, the input was 10 to 18V, and your system board needed about 24V power supply, and the power was large. The power of using ordinary DC-D